Re: [TEKNIK] MBR grub setup (hd0,0)

[Jørgen Heesche <sslug@sslug>]

David Bo Jensen wrote:
tak
----- Original Message ----- From: "Jørgen Heesche" <sslug@sslug>
Newsgroups: sslug.teknik
Sent: Friday, February 15, 2008 3:46 PM
Subject: Re: [TEKNIK] MBR grub setup (hd0,0)


> David Bo Jensen wrote:
>> grub > setup (hd0)
>> Vil placere stage1 i MBR
>>
>> grub > setup (hd0,0)
>> Vil placere stage1 i "boot record"  for første "primary 
partition". Dette er den første sector i "primary partition". Hvor 
stor er denne sector?
>> Vil ovennævnte også rette i MBR ? Hvis ikke hvodan startes stage1 
så op?
>>
>
> Hvis du installerer grub i en partition skal der være en anden 
bootloader i MBR.
> Se her:
> 
http://www.gnu.org/software/grub/manual/html_node/Installing-GRUB-natively.html
> 3.2 Installing GRUB natively
> Citat:
>      grub> setup (hd0)
>
> This command will install the GRUB boot loader on the Master Boot 
Record (MBR) of the first drive. If you want to put GRUB into the boot 
sector of a partition instead of putting it in the MBR, specify the 
partition into which you want to install GRUB:
>
>      grub> setup (hd0,0)
>
> If you install GRUB into a partition or a drive other than the 
first one, you must chain-load GRUB from another boot loader. Refer to 
the manual for the boot loader to know how to chain-load GRUB.
> Citat slut.
>
>
> --
> Med venlig hilsen
>
> Jørgen Heesche
> mailto:sslug@sslug
>
>