Re: [NOVICE] Lydkortproblem(er) ...fortsat

[Jan Hertel <sslug@sslug>]

Den 05-10-29 skrev Jan Hertel :
> Lasse Luttermann Poulsen skrev:
>
> <--- klip --->
> > >
> > > Er der slet ingen, der kan nogen fortælle mig, hvordan man til en
> > > begyndelse finder navn (og eventuelt andre data) på lydkortet?
> > >
> > Til at starte med kan du i en terminal skrive komandoen "lspci". den
> > skulle gerne give lidt info om pci enhedder på dit motherboard
> > (deriblandt er der ret sikkert et lydkort).
>
> Der ser da ikke ud til at være noget om det, jeg har brug for:
>
> $ lspci
> 0000:00:00.0 Host bridge: Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX Host
> bridge (AGP disabled) (rev 02)
> 0000:00:02.0 CardBus bridge: Toshiba America Info Systems ToPIC97 (rev 05)
> 0000:00:02.1 CardBus bridge: Toshiba America Info Systems ToPIC97 (rev 05)
> 0000:00:04.0 VGA compatible controller: Chips and Technologies F65555
> HiQVPro (rev c6)
> 0000:00:07.0 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ISA (rev 02)
> 0000:00:07.1 IDE interface: Intel Corp. 82371AB/EB/MB PIIX4 IDE (rev 01)
> 0000:00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev 01)
> 0000:00:07.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 02)
> 0000:00:0a.0 Communication controller: Toshiba America Info Systems
> FIR Port (rev 23)
>
>
> > > Jeg har forsøgt mig med at søge (Google) efter en løsning (til Toshiba
> > > Satellite 4000CDT og Ubuntu (5.10)) men uden det store held. Hvad gør
> > > man så for at finde en driver (hvis det er det der er problemet)?
> > >
> > Da Ubuntu er en relativ ny distrubution skal du nok ikke google´ med
> > det som kriterie, hvis du ikke finder noget.
>
> Ok!


Jeg har stadig ikke fået lyd på Ubuntuboxen. Men...

På http://www.accampbell.uklinux.net/linux/linux-toshiba.html er
beskrevet en installation af Debian på Toshiba Satellite 4000CDT (med
en opdateringsnote pr. 20041224). Afsnittet "Sound Configuration"
giver oplysning:

"1. First, make sure sound is enabled in tsetup.exe (Open the Toshiba
hardware tuning program (tsetup.exe). You can do this from within
Windows(TM), unless you've deleted it, in which case you can access it
by using the Toshiba Companion Diskette or from DOS (copy the relevant
file from the diskette)).

   2. Next, in Linux, configure the kernel in the Sound section to use
Yamaha OPL3SA2 and SA3 based PnP cards. (You could do this as a module
but I don't use modules so I compiled it in directly).

      See the Help file for further info. I did compile in the ISA PnP
support as suggested but still I needed to provide a kernel command
line when booting. I have:

      opl3sa2=0x538,5,0,1,0x530,1,0

      This goes in the BAT file for loadlin.exe in my case but the
same should apply in LILO. The above values come from setup.exe; if
you have difficulties you should check to see if your values are
different.

   3. When you reboot you should see messages about the sound card
being recognized. There may also be messages saying there was a
problem probing one of the ISA PNP cards and also about Control I/O
port 0x538 not being free but these don't seem to matter."

[1.] Jeg har set efter både direkte i BIOS og via tsetup.exe (the
Toshiba hardware tuning program), at "sound is enabled" (Toshiba
Companion Disketten starter selv op ved (re)boot). Lyden (lydkortet)
fungerede i øvrigt fint under tidligere installerede versioner af
Windows.

[2.] Ved søgning på Toshibaen på "OPL3SA" (uden anførselstegn) findes følgende:

/lib/modules/2.6.8.1-3-386/kernel/sound/isa/snd-opl3sa2.ko
/lib/modules/2.6.8.1-3-386/kernel/sound/oss/opl3sa.ko
/lib/modules/2.6.8.1-3-386/kernel/sound/oss/opl3sa2.ko
/lib/modules/2.6.8.1-4-386/kernel/sound/isa/snd-opl3sa2.ko
/lib/modules/2.6.8.1-4-386/kernel/sound/oss/opl3sa.ko
/lib/modules/2.6.8.1-4-386/kernel/sound/oss/opl3sa2.ko
/lib/modules/2.6.10-5-386/kernel/sound/isa/snd-opl3sa2.ko
/lib/modules/2.6.10-5-386/kernel/sound/oss/opl3sa.ko
/lib/modules/2.6.10-5-386/kernel/sound/oss/opl3sa2.ko
/lib/modules/2.6.12-9-386/kernel/sound/isa/snd-opl3sa2.ko
/lib/modules/2.6.12-9-386/kernel/sound/oss/opl3sa.ko
/lib/modules/2.6.12-9-386/kernel/sound/oss/opl3sa2.ko
/lib/modules/2.6.12-10-386/kernel/sound/isa/snd-opl3sa2.ko
/lib/modules/2.6.12-10-386/kernel/sound/oss/opl3sa.ko
/lib/modules/2.6.12-10-386/kernel/sound/oss/opl3sa2.ko

På (den oprindelige) Toshiba installation CD'en findes:

                       YAMAHA OPL3-SAx Sound System

                        Audio Driver for Windows 95

                              Ver 4.05.2338



                           Installation Manual

 --------------------------------------------------------------------------



This document is to describe the driver installtion for Windows 95.



[1] Contents of the installation diskette



  OPL3SA.DRV   : Main driver

  VOPL3SA.VXD  : Virtual main driver

  VYMIXD.VXD   : Virtual mixer driver

  VSGM.VXD     : Virtual soft synthsizer driver

  OPL3SACX.DLL : Power management application for the control panel

  OPL3SA.HLP   : Context help file for the power management application

  OPL3SACF.HLP : Context help file for the configuration application

  SASOUND.INF  : Inf file



  README.TXT   : Installation manual (this file)
<--- klip --->

Kan jeg hermed antage, at Ubuntu "... configure the kernel in the
Sound section to use Yamaha OPL3SA2 and SA3 based PnP cards..." så det
burde fungere på min Toshiba? Men hvorfor virker det så ikke? Hvorfor
kan jeg mon ikke se kortet med "lspci"? Kunne det tænkes at jeg også
"... needed to provide a kernel command line when booting"? I så fald
hvad og hvordan gør jeg (det)? Eller er der andet jeg kan foretage mig
i denne forbindelse?


--
/Jan